RESETTING TRIPS IN DR and RICH

1. Open the Detector-Based Adjustment Frame GUI

2. If there are channels listed in the lower half of the window, press ‘Clear All’ for the system they belong to.

3. Select the tripped channels.

4. Right click on BEN column and change value to 0 to disable bulk.

5. Hit ‘Refresh’ a few times to make sure the BEN column goes to 0

6. Continue to Hit ‘Refresh’ until BMV is below 100 Volts

7. Right click on CEN column and change value to 1 to reset the trip.

8. Hit refresh several times and make sure trip is reset.

9. Right click on BEN column and change value to 1 to ramp up the HV.

10. Any Questions? PLEASE CALL THE HV EXPERT!